ProForm PFTL39920 Bedienungsanleitung PDF herunterladen (Seite 7)

9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may

be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the

walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.

8. Attach the Storage Latch (14) to the left Handrail (102)

with two 3/4” Screws (13). Be careful not to over-

tighten the Screws.

Lift the treadmill frame (see HOW TO FOLD THE

TREADMILL FOR STORAGE on page 11), but do not

latch it. Make sure that the frame is centered between

the Handrails (102, 103 [not shown]). Firmly tighten all

of the bolts and screws used in assembly steps 3, 4,

5, and 6. Then, lower the frame to the floor.

102

7. Hold the Console (10) near the Console Base (46). Touch

the Right Handrail (103) to discharge any static. Plug

the widest connector on the Wire Harness (21) into the

widest connector on the Console. If the connector does

not fit easily, rotate it and then connect it. Plug the other

connector on the Wire Harness into the other connector on

the Console. Insert the excess Wire Harness down through

the opening in the Console Base (see the inset drawing

in step 6 above). Securely tighten the plastic tie on

top of the Console Base to prevent the Wire Harness

from slipping. Then, cut off the end of the plastic tie.

Refer to drawing 7a. Press the Book Rack (101) onto the

Console Base (46) in the location shown.

Set the Console (10) on the Console Base (46). Insert

the excess Wire Harness (21) into the large hole in the

side of the Right Handrail (103). Securely tighten the

plastic ties on the bottom of the Console Base to

prevent the Wire Harness from slipping. Then, cut off

the ends of the plastic ties.

Attach the Console (10) to the Console Base (46) with two

1/2” Silver Screws (118) and four 3/4” Screws (13). Start

all six Screws before tightening them; do not over-

tighten the Screws.

118

103

Ties

110

Ties

103

6. Place the Console Base (46) on the Right Handrail (103)

and the Left Handrail (not shown). Attach the Console

Base with four 1 1/4” Screws (105) (only two Screws are

shown).

Do not tighten the Screws yet.

Insert the Wire Harness (21) through the two indicated

plastic ties on the Console Base (46). Next, insert the

Wire Harness up through the opening beside the Console

Cover (110). Make sure that the Console Cover is se-

curely attached to the Console Base.

Refer to the inset drawing. Look at the top of the Console

Base (46). Insert the Wire Harness (21) through the plas-

tic tie on top of the Console Base.

Tie

105

101

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Kommentare zu diesen Handbüchern

Keine Kommentare

ProForm PFTL39920 Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Laufbänder ProForm PFTL39920