ProForm PFTL39920 Bedienungsanleitung PDF herunterladen (Seite 6)

4. Hold the Crossbar (1) between the Handrails (102, 103).

Attach the Crossbar with two Crossbar Screws (53). Do

not tighten the Crossbar Screws yet.

Attach the ring on the end of the ground wire to the small

hole in the side of the Right Handrail (103) with a Silver

Ground Screw (109).

3. Insert a Plastic Shim (104) into each side of the post on

the right side of the Base (11). Next, orient the Right

Handrail (103) as shown, and insert it into the Base. Be

careful to avoid pinching the Handrail Wire Harness

(21). Note: If necessary, tap the Right Handrail with a

rubber mallet until it is fully seated in the Base. If the

Right Handrail cannot be fully seated, remove the outer

Plastic Shim and then insert the Right Handrail.

Attach the Right Handrail (103) to the Base (11) with

three 1” Bolts (8) and three 1/4” Star Washers (9). Do

not tighten the Bolts yet.

Assemble the Left Handrail (not shown) in the same

way. Note: There is not a wire in the Left Handrail.

103

104

Ground

Wire

102

109

103

5. Hold the Left Upper Body Arm (89) near the Left Handrail

(102) as shown. Make sure that the Resistance Knob

(98) is on the indicated side. Attach the Left Upper Body

Arm to the Left Handrail with two 3” Bolts (78), two

Washers (39), and two 3/8” Star Washers (29) as shown.

Attach the Right Upper Body Arm (94) to the Right

Handrail (103) as described above. Be careful not to

pinch the wires in the Right Handrail.

103

102

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Keine Kommentare

ProForm PFTL39920 Bedienungsanleitung Seite 6